Campbell Hausfeld TL0502 Operations Instructions download pdf (Page 6)

Symptom Possible Cause(s) Corrective Action

Tool runs slowly or will not

operate

1. Grit or gum in tool 1. Flush the tool with air tool oil, gum solvent,

or an equal mixture of SAE 10 motor oil

and kerosene. If air tool oil is not used,

lubricate the tool after cleaning

2. No oil in tool 2. Lubricate the tool according to the

lubrication instructions in this manual

3. Low air pressure 3. a. Adjust the regulator on the tool to

the maximum setting

b. Adjust the compressor regulator to tool

maximum while the tool is running

free

4. Air hose leaks* 4. Tighten and seal hose fittings if leaks are

found

5. Pressure drops 5. a. Be sure the hose is the proper size.

Long hoses or tools using large volumes

of air may require a hose with an I.D.

of 1/2 inch or larger depending on the

total length of the hose

b. Do not use a multiple number of hoses

connected together with quick connect

fittings. This causes additional pressure

drops and reduces the tool power.

Directly connect the hoses together

6. Worn ball bearing in motor 6. Remove and inspect bearing for rust, dirt

and grit or worn race. Replace or clean and

regrease bearing with bearing grease

Troubleshooting Chart

Stop using tool immediately if any of the following problems occur. Serious personal injury

could occur. Any repairs or replacements must be done by a Qualiﬁed Service Person or

Authorized Service Center.

Operating Instructions

www.chpower.com

USER-MAINTENANCE

INSTRUCTIONS

TECHNICAL SERVICE

Please call our Tool Hotline at 1-800-

543-6400 with any questions regarding

the operation or repair of this tool or

for additional copies of this manual.

REPLACEMENT PARTS INFORMATION

For information regarding where to

order replacement parts, call toll free

1-800-543-6400. Please provide the

following information:

 •Modelnumber

 •Stamped-incode

 •Partnumberanddescription

TOOL REPAIR

Only qualified personnel should repair

the tool and they should use genuine

Campbell Hausfeld replacement parts

and accessories, or parts and accessories

which perform equivalently.

ASSEMBLY PROCEDURE FOR SEALS

When repairing a tool, the internal

parts must be cleaned and lubricated.

Parker O-lube or equivalent must be

used on all o-rings. Each o-ring must be

coated with O-lube before assembling.

A small amount of oil must be used on

all moving surfaces and pivots. After

reassembling, a few drops of 30W

non-detergent oil or equivalent, must

be added through the air line before

testing.

STORAGE

The impact wrench must be lubricated

before storing. Follow the air motor

lubrication instructions with an

exception to step 4. Only run the impact

wrench for 2 to 3 seconds instead of 20

to 30 seconds because more oil needs

to remain in the impact wrench when

storing. The tool should be stored in a

cool dry place.

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Comments to this Manuals

No comments

Campbell Hausfeld TL0502 Operations Instructions Page 6

Comments to this Manuals

Related products and manuals for Power impact wrenches Campbell Hausfeld TL0502