Campbell Hausfeld Air Powered Flooring Nailer / Stapler CHN50300 Operations Instructions download pdf (Page 13)

CHN50300

www.chpower.com

PROJECT MATERIALS LIST:

u Wood Flooring u Flooring Fasteners (L-Cleats or staples)

u Finish Nails u Underlayment u Tape

PROJECT TOOLS LIST:

u Flooring Nailer u Finish Nailer u Circular / Miter Saw

u Jig Saw u Air Compressor u Air Hose

u Drill u Drill Bits u 30 W Non-Detergent Oil

u Tack Hammer u Pry Bar u Utility Knife

u Tape Measure u Tooth Hand Saw u Carpenter’s Square

u Pencil u Chalk Line u ANSI Z87 Eye Protection

u Small Tool For Clearing Jams u Removeable Threadlock Glue

RACKING THE FLOORING

(See FigureS 20 and 21)

First refer to flooring manufacturer’s preparation procedures regarding moisture

content and floor preparation before laying the flooring boards.

To correctly install hardwood flooring, it must be properly racked before being nailed

into place. After placing the first board, follow these instructions to rack the flooring:

1. Place flooring groove onto the tongue of previously installed board.

2. Use the rubber end of the mallet to “pop” the tongue into the groove (

see Figure 20).

3. Use the metal end of the mallet to rack the board tightly against adjacent board. The

metal end is tapered away from top of flooring to prevent unwanted damage to top

surface (see Figure 21).

FIRING THE NAILER

NOTE:

Make sure the rubber bumper on the flooring nailer is in the up position before

adding the air hose, if not, the nailer may cycle (see Figure 15).

1. Connect the air supply to the nailer.

2. Load fasteners (see Loading/Unloading the Nailer section).

Do NOT ﬁre the tool unless it is securely placed. If tool is notsecurely

placed, there is a risk of ﬂying fasteners that may cause death or serious

injury.

An improperly functioning tool must not be used. Do not actuate

the tool unless the tool is placed ﬁrmly against the work piece.

3. Place the tool on the floor (see Figure 22) with the shoe plate resting on the racked

floor board. Make sure the fastener ejection nozzle is firmly placed against the board

tongue.

Operation

Figure 20 - “Pop” the tongue into the

groove

Figure 21 - Rack the board tightly

against adjacent board

Figure 22 - Rest shoe plate on floor

board

Refer to flooring manufacturer’s preparation

procedures regarding moisture content and floor

preparation before laying the flooring boards.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 55 56

Comments to this Manuals

No comments

Campbell Hausfeld Air Powered Flooring Nailer / Stapler CHN50300 Operations Instructions Page 13

Comments to this Manuals

Related products and manuals for Nail Gun Campbell Hausfeld Air Powered Flooring Nailer / Stapler CHN50300