It is the owner and/or operator’s responsibility to study all WARNINGS, operating, and maintenance instructionscontained on the product label and inst
1011 A0308-0241 Firing Valve Piston12 A0200-0251 O-Ring13 A0200-0081 O-Ring14 A0205-0111 Gasket15 A0200-0721 O-Ring16 A0602-0171 Piston Head17 A0011-0
59 A0000-0211 Screw60 A0000-0011 Screw61 A0005-0051 Washer62 A0004-0001 Hex Nut63 A0709-0081 Click Lever64 A0103-0061 Spring65 A0706-0201 Spring Holde
12NAILER PARTS DIAGRAM,,,,,
131 A0304-0301 Exhaust Valve Collar2 A0200-1261 O-Ring3 A0000-0101 Screw4 A0005-0031 Washer5 A0301-0141 Cylinder Cap6 A0311-0121 Air Seal7 B0300-0671
14No. Part No. DescriptionSTAPLER PARTS LISTING49 A0100-0211 Compression Spring50 A0711-0463 Release Catch51 A0801-0901 Driver Guide52 A0801-1161 Driv
15STAPLER PARTS DIAGRAM,,,,96
The owner and/or operator is responsible for maintenance, maintaining all decals or warning labels andwhile in use, maintaining the unit in good worki
3NAILER/STAPLER SPECIFICATIONSCompressed Air:Maximum permissible operating pressure: 120PSI (0.8 MPa)Recommended operating pressure range: 60-100PSI (
4NAIL/STAPLE INFORMATIONFastener Gauge 18 Gauge Brad Nails 18 Gauge Crown StaplesFastener Lengths 5/8"-2" 3/8"-1"QuickPlugQuick Pl
UNPACKING & INSPECTIONDo not operate this air nailer/stapler if damaged during shipment, handling or mis-use. Damage may result in bursting, which
USE COMBUSTIBLE GASSES OR ANY OTHER REACTIVE GAS AS A POWERSOURCE FOR THIS NAILER/STAPLER. Explosion and serious personal injurycould occur.• Use clea
7Checking the Nailer/Stapler for Proper Operation:BEFORE EACH USE, YOU MUST CHECK FOR THE PROPER OPERATION OFTHE WORK CONTACT ELEMENT (WCE).• The WCE
• For the nailer/stapler to operate, your finger must first be off the trigger and the work contact elementof the nailer/stapler then pressed against
9Problem SolutionsLoose screws. Tighten screws.Worn or damaged o-rings or seals Contact factory for service. 1-800-423-3598Symptom: Air leak near top
Comments to this Manuals