Campbell Hausfeld HU502000 Operations Instructions download pdf (Page 5)

5

HU500000, HU502000

www.chpower.com

Installation

LOCATION

It is extremely important to install the

compressor in a clean, dry, and well

ventilated area. The compressor must

be placed on a firm, level surface where

the surrounding air temperature will

not be more than 100°F.

A minimum clearance of 18 inches

between the compressor and a wall is

required because objects could obstruct

air flow.

Do not locate the

compressor air inlet

near steam, paint spray, sandblast areas

or any other source of contamination.

This debris will damage the motor.

ELECTRICAL INSTALLATION

All wiring

and

electrical connections should

be performed by a qualiﬁed

electrician. Installation must

be in accordance with local codes and

national electrical codes.

WIRING

1. Local electrical wiring codes

differ from area to area. Source

wiring, plug and protector must

be rated for at least the amperage

and voltage indicated on motor

nameplate, and meet all electrical

codes for this minimum.

2. Use a slow blow fuse or a circuit

breaker.

3. This product is for use on a

nominal 120 volt circuit and has

a grounding plug that looks like

the plug illustrated in Figure 6.

Make sure the product is connected

to an outlet having the same

conﬁguration as the plug. This

product must be grounded. In the

event of an electrical short circuit,

grounding reduces risk of electrical

shock by providing an escape wire

for electric current. This product

is equipped with a cord having a

grounding wire with an appropriate

grounding plug. Plug must be

plugged into an outlet that is

properly installed and grounded in

accordance with all local codes and

ordinances.

Overheating, short

circuiting and ﬁre

damage will result from inadequate

wiring.

TEST

RESET

Figure 6 - Grounding Method

Grounded Outlet

Grounding Pin

Operation

BEFORE FIRST START-UP

BREAK-IN PROCEDURE

(Complete this procedure before using

compressor for the first time. Once

completed, it is not necessary to repeat.)

1. Open drain valve located on bottom

of tank.

2. Turn ON / OFF switch to OFF

position.

3. Plug in power cord.

4. Turn ON / OFF switch to ON position

and run compressor for 30 minutes.

5. Turn ON / OFF switch to OFF

position.

6. Unplug power cord.

7. Close drain valve.

The compressor is now ready for use.

OPERATING PROCEDURE

1. Turn switch to OFF position and plug

in power cord.

2. Turn regulator knob

counterclockwise to close air flow.

3. Turn switch to AUTO position.

4. Compressor will build to maximum

pressure and shut off.

5. With hose attached to outlet of

compressor, attach tire chuck or

other tool to open end of hose.

6. Adjust regulator to proper pressure

for tool or tire. Operate tool per

instructions.

As air is depleted from the tank by

use of a tire chuck, tool, etc., the

compressor will restart automatically

at its preset “cut-in” pressure. When

a tool is being used continuously,

the compressor will cycle on and off

automatically.

7. Turn switch to OFF position, unplug

power cord and drain tank of air

when finished using compressor.

Minimum Gauge of Extension Cord

25 ft. 50 ft. 100 ft.

14 12 10

Use of an extension cord may cause excess

heat to motor. This could lead to tripped

breaker (at electrical panel) or tripped

thermal overload (on compressor motor).

If this occurs, eliminate extension cord and

plug compressor directly into electrical

outlet. Avoid using extension cords; use

longer air hose(s) instead.

1 2 3 4 5 6 7 8 9 10 ... 31 32

Comments to this Manuals

No comments